+44 (0)1432 365 000
tel icon
Total Process Cooling
Slide background
Minimise the risk of downtime from damaged or burst pipework with our range of fluid solutions...
Antifreeze
Non Toxic
Optimum Flow
Protection
Biodegradable
Quality Assured
Process Cooling Systems & Solutions
<<  back

DTX-HT: DeTox Glycol (High Temperature)

High Efficiency Non Toxic Heat Transfer Fluid with Antifreeze. Based on Ethylene Glycol blended with patented DeToxTM additive and ASTM D1384 High Temperature Rated Corrosion Inhibitors for use in Hot Water Heating Systems.

Performance Properties

DTX-HT: DeTox Glycol (High Temperature) has been especially formulated for use in Refrigeration and HVAC systems to expolit the advantages Ethylene Glycol has over Propylene Glycol, whilst delivering a non toxic solution. Specifically; more efficient heat transfer, easier to pump (especially at low temperatures), less volume for the same freeze protection and cheaper per litre.

Antifreeze

DTX-HT: DeTox Glycol (High Temperature) is miscible with water in all proportions and can protect Hot Water Heating systems down to -50 °C depending on concentration.

Non Toxic

DTX-HT: DeTox Glycol (High Temperature) is based on Ethylene Glycol. It has been tested and classified as Non Toxic by an EPA certified laboratory. Previously Propylene Glycol was the only non toxic glycol available, however with the introduction of the patented DeToxTM additive that is no longer the case. DeToxTM prevents Ethylene Glycol from being metabolised (during digestion) into toxic by-products, which cause kidney failure, blindness and death. Tests carried out on DTX-HT confirmed the toxicity was “so low that it was impossible to determine and LD50 value”. The DeToxTM additive has very little effect on heat transfer or antifreeze performance. In fact similar volumes of DTX-HT or Ethylene Glycol are required to achieve a specific freeze protection.

Optimum Flow

DTX-HT: DeTox Glycol (High Temperature) has improved heat transfer characteristics including lower dynamic viscosity and higher thermal conductivity. For a detailed comparison please refer to the Fluid Performance Chart which is available upon request.

Protection

DTX-HT: DeTox Glycol (High Temperature) contains synergistic corrosion inhibitors to protect metals commonly found in such systems. It has been independently tested and found to meet BS6580 and ASTM D1384 corrosion standards. DTX-HT: DeTox Glycol (High Temperature) also contains scale and biological inhibitors to help prevent fouling - thus promoting long operational life and high thermal efficiency.

Biodegradable

DTX-HT: DeTox Glycol (High Temperature) mixtures are readily biodegradable (90% over 10 days) and will not remain in the environment or bio-accumulate.

Quality Assured

All BDIC Glycol products are manufactured in accordance with certified ISO 9001-2008 procedures.

Physical Properties

DTX-HT: DeTox Glycol (High Temperature) is a clear, slightly viscous liquid and mildly sweet to the taste. It is non-pungent however it does have a characteristic aroma.

Density: 1.04 - 1.15 g/cm3
pH: 7.5 - 10.5 depending on inhibitors
Boiling Point: >100 °C
Application

As per BSRIA guide BG 29/2012 all pipework systems should be clean and free from biological contamination and debris prior to commissioning. To minimse corrosion, air ingress should be minimised. A pressurised system is best.

Determine the total system volume and add DTX-HT: DeTox Glycol (High Temperature) to the system according to the minimum operating temperature required (see table below).

The minimum dose of DTX-HT: DeTox Glycol (High Temperature) should not be less than 22% of the system volume and the maximum does not normally exceed60%. We recommend the use of deionised, distilled or UltraPure™ water for this dilution. Avoid water containing high levels of calcium salts or chlorides [CI-].

Diluting Concentrate

When measuring the percentage concentration of DTX-HT: DeTox Glycol (High Temperature) insolution we recommend the use of a recently calibrated refractometer.

Health & Safety

Please refer to the associated product Safety Data Sheet which is available on request.

Shelf Life

3 years when stored in sealed containers out of direct sunlight.

Available in

25, 205 & 1000 Litre IBC’s and bulk tankers.

DTX-HT: DeTox Glycol (High Temperature) can also be supplied as a ready-to-use solution.

Frost Protection °C V/V of DTX-HT: DeTox Glycol (High-Temp) Refractive Index
-10 22% 1.356
-15 28% 1.362
-20 33% 1.367
-25 38% 1.372
-30 42% 1.376
-35 46% 1.380
Support Services

BDIC strive to ensure end users and distributors receive the full benefit of working with a specialist supplier that offers:

  • Expert Technical advice on all aspects of fluid selection, including Environmental Impact Assessments, Thermal Performance etc
  • Fluid Maintenance Programs for the proactive verification of fluid and system condition
  • A vast stock inventory facilitating same day dispatch and delivery
  • Bespoke formulations for specialist applications.

For further information about this product please email: [email protected]